product type
Two component polyamide cured epoxy micaceous iron coating (containing micaceous iron oxide powder)
Description of high build epoxy micaceous iron intermediate paint
Color and appearance light gray medium light
Volume solid content (%) 53 + 2
Features - excellent adhesion at long painting intervals - intermediate paint for anti-corrosion system - excellent physical and mechanical properties such as hardness, impact resistance, friction resistance, etc. - easy to construct
It is usually used as epoxy intermediate paint for many kinds of factory buildings, steel structures, inner walls of tanks and bridges
Product information 5402 general information
Flash point main agent: 23.0oc curing agent: 27.0oc
Specific gravity (mixture): 1.54 + 0.05 g / ml (ISO 2 811)
5. O.C. content: 439g / L
Dangerous goods grade / packing category: main agent 3 / II curing agent 3 / III
Dangerous goods shipment No.: 1263
Packaging and operation information
Specification: two component
Main agent: colored liquid
Curing agent: translucent liquid
Due to the different needs of different countries and regions, the packaging specifications are also different.
Storage conditions - must comply with national regulations - maintain good ventilation conditions - keep away from heat and fire temperature: 5 - 50 OC humidity: 0 - 90% RH 25 OC storage time: December
Packaging must be handled in a separate closed container in accordance with all relevant regulations.
surface treatment
The general surface to be coated must be thoroughly cleaned (to remove rust, dust, oil, grease, etc.) and dried (the substrate temperature must be 3 ℃ or more higher than the dew point temperature). This product should be used together with the previous coating.
Before painting Epicon f-Hb, the damaged surface must be correctly coated with a matching anti-corrosion primer according to the coating instruction manual.
Construction conditions
The product is a two-component product mixed with epoxy thinner a, a RH diluent with a minimum temperature of 5 OC and a maximum humidity of 85%. After mixing in the correct proportion, it must be used within the specified time range.
Epicon series, galbon series, univan series, umeguard series, etc
After matching coating Epicon series, unymarine series, fluorex series, evamarine and so on
Airless spraying nozzle gun pressure gun speed viscosity dilution
Graco 415, 417 14.7 - 17.7 MPa (g) 60 - 80 cm / s 80 - 100 seconds (Ford 4 cups) 0 - 15% (volume ratio)
Brush / roll - dilute
Generally, it can reach 50 μ M 0 – 10% (volume ratio)
-Sharp edges, screws and cracks shall be precoated with brush. -In general, epoxy coatings (including this product) tend to be powdered, yellowing and discolored when exposed to sunlight for a long time. -All dust and pollutants shall be removed before the construction of the subsequent coating. -If the construction site is relatively closed, there must be sufficient ventilation conditions to remove solvent vapor during the construction and drying process. -Construction workers must take appropriate protective measures, such as wearing protective glasses, gloves, gas masks, etc. -This product shall not be exposed to water.
Security
This product must be painted by professional construction personnel. Please refer to CMP's chemical safety instructions. Abide by the national and regional rules and regulations on health, safety and environmental protection. Read all safety instructions on packaging and containers. Take precautions against fire or explosion and protect the environment. Construction in a ventilated environment. Operate carefully.